|
|
#1
September 18th, 2011, 17:47
| |||
| |||
 routing kong to nn-xt First post... I would like to be able to route my Kong pads through NN-XT, which would allow me to MIDI map the knobs in NN-XT onto my controller, so I can master control each pad sound with 1 knob. Instead of individually putting samples into the Kong NN-XT Nano, I'd like to plop them into NN-XT. I hope this is clear. Thanks!  |
|
#2
September 18th, 2011, 23:39
| |||
| |||
|
Just set up single-note zones in the NNXT and load your samples there. The pads correspond to notes C1, C#1, D1... and so on. You don't need Kong at all.
__________________ This forum is no longer supported. As of Oct 1, 2011 we have moved to THE NEW REASON FORUMS. |
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Kong Drum Mapping Issues | BusinessPants | Reason | 2 | May 16th, 2012 08:05 |
| Kong & Redrum Set-up | Jayson Wonder | Reason | 2 | July 20th, 2011 22:22 |
| kong | thejoseph | Reason | 1 | June 10th, 2011 01:52 |
| Kong | jonny387 | Reason | 2 | June 1st, 2011 01:25 |
| Samples in Kong | Simzilla | Reason | 3 | May 21st, 2011 04:31 |
Linear Mode
