Hello to everyone since it's my 1st post here.To begin with,i am using axiom 25 and reason 4.0.1 for some months already,but yesterday it suddelny stopped working knobs and pads.Actually the some of the pads when i press them work as knobs :S i have re-installed m audio's drivers/updates for axiom.i even upgraded reason 4.0.1 to 4.0.1 again.i deleted the axiom from the control surfaces and re-installed and yet again,nothing changes,keys work fine,and stop/play/record/loop buttons work,but i think they work a little bit "slower",like there is a very small delay from when i press it until it does it.


plz help me !

Same thing happened to me i downloaded something called m audio control surface i think its on there website then i pressed recall on the axiom and selected 10 which is reason try it let me knw how it goes

so,everything is ok now.i dont know exactly what i did,i made a reset,then a recall and then i think i re-assigned axiom in reason.altough,from the m-audio support forum a technician gave me this answer :


"Your tests in MIDI-OX show that the Axiom is working. It sounds like the Axiom isn't sending the MIDI messages that Reason expects. Delete the Axiom from Reason's MIDI preferences, the click auto-detect, let it overwrite Preset 10. Then press Recall On the Axiom, if all Groups A, B, and C aren't active/flashing, press all 3 group buttons at the same time so they are, then press +/- to select P09. When it stops flashing press Recall and + to select P10. When it stops flashing the Axiom should be setup to send the correct MIDI messages for the Reason control surface setup."

I put this here in case someone faces the same problem as me,coz i f*** turned the net upside down to fix it

cu around producers